ZOKU Quick Pop Maker Instrukcja Użytkownika Pobierz pdf (Strona 11)

10

The tip of the Quick Pop stayed in the mold.

The stick was not fully inserted into the mold

cavity. Be sure the stick is fully seated in the

mold cavity BEFORE pouring the juice.

The tabs on the stick will not sit properly in

the mold.

Make sure that the sticks are inserted

BEFORE POURING JUICE, and that there are

no other ingredients at the bottom of the

mold cavity (nuts, fruit etc.) If sticks are not

seated properly, the pops will not pull out.

The Quick Pops take a very long time to

freeze or won’t freeze at all.

The Quick Pop Maker was not completely

frozen. Be sure to freeze the unit for 24 hours.

The freezer temperature is not cold enough.

In order to properly freeze the Quick Pop

Maker, your freezer needs to be set to 0°F.

(-18°C) or below, which is also the ideal

temperature for food storage.

Try placing the unit in a different part of the

freezer; different parts of the freezer have

different temperatures.

The ingredients are too warm.

Multiple batches of Quick Pops are possible

if done in quick succession. Too much time

between batches or warm ingredients will

cause the Quick Pop Maker to defrost.

Unique Quick Pops take a bit longer to make

than single ﬂavored pops. Also, the number

of batches may be reduced when making

unique pops.

My ﬁnger is stuck to the cavity.

If your ﬁngers are stuck to the Quick Pop

Maker, run your ﬁngers under warm water.

Do not touch the metal part of the Quick Pop

Maker when it is frozen.

The Quick Pop Maker container is broken,

and the liquid inside is everywhere.

The refrigerant liquid is non-toxic, but do not

try to use the Quick Pop Maker any longer. It

should be discarded immediately.

I lost my Super Tool/stick/drip cup.

Visit www.zokuhome.com to order

replacement parts.

1 2 ... 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag